Inverto 18R Deluxe Frame
ca. 1938-1993 Right Side View Approx. 173mm tall (lever in closed position) Shown with No. 1 setting punch and No. 540 Friction Jeweling Attachment installed. Note: Lock collar on No. 1 Setting Punch is not a standard part.
|
Back View
Shows locking knob for die plate Knob is die struck or cast steel with chrome plating.
|
Die Plate Top Left Oblique View
26 hole die plate Die plate diameter (knurled edge): 50mm Die plate work surface diameter: approx. 45.5mm
|
Top Left Oblique Detail View
Shows micrometer adjustment screw with 0.02mm divisions for No. 540 Friction Jeweling Attachment
|
Top Right Oblique Detail View
Shows micrometer adjustment screw with 0.02mm divisions and post with 1mm divisions for No. 540 Friction Jeweling Attachment. For a better view of the graduated post, see the right side view above.
|
Bottom View
Frame serial number 981B Shows die plate retaining screw.
|
Lower Front Detail View
Shows die plate retaining nut/collar with holes for tommy bar/pin spanner.
|
18R Deluxe Tool Set
Complete set of stumps and stakes (ex. stump 19F) Complete set of accessories (ex. 3 broken sub-punches for No. 120 Sub-punch holder & broken #7 reamer) Three extra stakes (top center, to left of opening for frame)
|